Skip to the content
Handiwork Haven

Long-tail cast on

A neat, stretchy way to put your first row of stitches on the needle, using both ends of the yarn.

Written in patterns as COLevel: Start here
long tailto ball

Step 1 of 6

Measure a long tail: about 2.5 to 3 cm (1 in) for each stitch you need, plus 15 cm (6 in). Tie a slip knot there and put it on the needle.

If it goes wrong

The tail runs out before you have all your stitches
Pull it all out and start again with a longer tail. To measure exactly, wrap the yarn loosely round the needle once for every stitch you need, then add 15 cm.
The cast on is so tight you can't knit the first row
Leave a gap about the width of the needle between stitches, and don't yank each one tight. Or cast on over two needles held together, then pull one out.
The stitches are different sizes
Snug each stitch the same small amount by spreading thumb and finger, rather than pulling the ends.

Tips

  • The slip knot counts as stitch number one.
  • The side facing you as you cast on shows little bumps. Many knitters treat it as the wrong side.