Skip to the content
Handiwork Haven

Threading and knotting

How to cut the right length of thread, get it through the needle, and tie a knot that holds.

Level: Start here
about 60 cm (24 in)cut at a slant

Step 1 of 6

Cut a piece of thread about an arm's length long: around 60 cm (24 in). Cut it at a slant with sharp scissors, so the end is clean and pointed.

If it goes wrong

The thread won't go through the eye
Cut a fresh, slanted end: a frayed one won't fit. A needle with a bigger eye or a needle threader also helps.
The needle keeps falling off the thread
Leave a longer tail, about 10 cm (4 in), and hold the tail against the needle for the first few stitches.
The knot pulls straight through the fabric
Make a bigger knot: wrap four or five times instead of three, or tie a second knot on top of the first.
The thread twists and tangles
Use a shorter length. When it starts to twist, let the needle hang down freely and it will untwist itself.

Tips

  • For sewing on buttons, use doubled thread: pull both ends level and knot them together as one.
  • Pick thread that matches your fabric, or a shade darker. It hides better than a lighter one.